Third, it’s important to be gentle when cutting hair. scissors should be used in a light, sweeping motion to avoid snagging and pulling the hair. All three types of shears are often referred to as thinners, but each type has its own characteristics, with blenders generally being the most popular choice for groomers. Whereas a texturizing shear can have as little as 7 teeth on the shear when cutting with these scissors though extra care is normally taken each time because a lot more hair is removed due to the fewer teeth on the shear. Section off the top of their hair along their natural part. Everyone has a natural part shaped like a horseshoe where the top of their scalp meets the sides of their head.

Original Blend Frend - Grade 1 (3mm) Blend comb/Barber comb

If it is a lot then your text shear is best used to take away that unwanted weight without disturbing the cut. Good, I hope you did. Chipping into the ends of your hair is I guess a little harmless if you know what you're doing but when you whip that blending shear out you may not like the amount of hair that will come off. If you want to go from a dark color to a light color, you’ll need to bleach your hair first. Be sure to do a strand test to make sure your hair is light enough, and to determine how much bleach to use. Once your hair is light enough, you can dye it the lighter color. Comb all of the hair on top of the person’s head forward so you can see their part. That way, you won’t accidentally cut off too much hair or give the person an unnatural part. [5] X Research source For a natural, textured result, choose shears that have teeth that are larger than the spaces between them.Cut in sections around their head until you reach the other side. Place your comb at the bottom of their hairline to start the next vertical section of the haircut.

Simple Ways to Do Clipper over Comb: 15 Steps (with Pictures)

Another way to blend your hair with a comb is to use it to section your hair into small subsections. Take one subsection and use a comb to smooth it down, then take the next subsection and do the same. Continue until your entire head is done. Each thinning shear that we’ve discussed is readily available in a range of sizes and with a differing number and spacing of teeth and this can impact on your end result too. It’s important to bear the following teeth-related points in mind when choosing your shears;- Blenders are used to finish off a groom, blending away severe scissor and clipper lines and softening the cut. Best used ¼” to ½” away from the hair tips, they are characterised by having teeth down one edge and a solid blade on the other. They remove more hair per cut than double-bladed thinners and are the best choice for blending short hair into long for a seamless finish. Position your comb so the teeth point up. Pinch the base of the handle with your index finger and thumb. Loosely wrap your other fingers around the lower half of the handle so the comb doesn’t slip around while you’re using it. [8] X Research sourceThere are a few different techniques that you can use to blend a fade with scissors. The most popular technique is to use a blending comb. A blending comb is a small, flat comb that has been specifically designed for blending hair. It has evenly spaced teeth that help to smooth out the hair and create a seamless transition between the hair lengths. To blend your hair from one color to another, you’ll need to mix the two colors together. Be sure to test the color on a strand of hair before you apply it to your entire head, as the color may be different than what you expect. Apply the color to your hair using a brush or your fingers, and be sure to cover every strand. Leave the color on for the recommended amount of time, then rinse it out.