The simple instructions below are designed to help with the programming of the unit. All the following instructions require the front flap to be lowered. Please replace the flap when normal operation is required. SETTING DAY AND TIME OF DAY This is the Horstmann CentaurPlus C27, a two channel programmer which gives independent control over hot water and heating with up to 3 ON/OFF settings for each day of the week. It also has a 1 hour manual boost button for the hot water and an advance button for the central heating. lt;li>Operating periods per day: 3 per day for Central Heating and 3 per day for Hot Water</li>

The installer will have set the programmer to suit the installed system. If this is a Fully pumped system this will allow independent control of the Central heating and Hot water, however on a Gravity system the Central heating and Hot water are linked so that it is not possible to use the Central heating independently. This will allow only one common time setting for both Hot Water and Central Heating. BATTERY On the ChannelPlus display - Boost 1 is Hot water extension 1 or 2 hour and Boost 2 is Heating extension 1 or 2 hours ADVANCE FUNCTIONThe programmer is fitted with a non-rechargeable, long life battery, which will maintain the programmed time settings for a minimum of ten months with the supply disconnected. If a Heating or Hot water period is not required it can be cancelled by setting the ON and OFF settings to the same time. Example ON 10:00am OFF 10:00am Your programmer will prevent you from accidentally overlapping ON and OFF times. Example: If the 2nd ON time is set at 12:00pm and then you try and set the 1st OFF at 12:30 pm the OFF setting will 'bounce' by a 10 minute period until the 2nd ON time has been adjusted. FULLY PUMPED OR GRAVITY SYSTEM

Using the RESET procedure may rectify the fault. If the problem persists the programmer will need replacing. Override: 1 hour boost (Hot Water only), 1 hour extension to On period (Hot Water only), instant advance (Central Heating only) lt;li>Override: 1 hour boost (Hot Water only), 1 hour extension to On period (Hot Water only), instant advance (Central Heating only)</li>During power interruptions the display will be blank, after 3 days the current time of day will be lost. If the programmer is not to be used for a long period of time, the switch on the rear of the unit should be returned to the BATTERY OFF position. These are both to prolong the battery life. SERVICE AND REPAIR lt;p>This is the Horstmann CentaurPlus C27, a two channel programmer which gives independent control over hot water and heating with up to 3 ON/OFF settings for each day of the week. It also has a 1 hour manual boost button for the hot water and an advance button for the central heating.</p> This indicates that you have reached an existing set time period, you will be unable to set a new ON/OFF time unless there is an alteration to the existing timed period The Secure Meters Horstmann CHANNELPLUS H27XL is a white 2 channel 7 day electronic digital programmer with independent timing of heating and hot water.. User friendly, it is designed for domestic use, providing advanced, easily programmed features.

Should you encounter any problems, please refer to the Question and Answer section SPECIAL FEATURES

Secure (Horstmann)

Whilst the HOLIDAY FUNCTION is in operation the system will remain OFF, the display will show the number of nights remaining. The HOLIDAY setting is an instant function and cannot be set in advance. The HOLIDAY FUNCTION can be cancelled at any time by pressing any of the SELECT buttons. Normal programme functions will resume at the first ON period after the pre-set number of nights has expired. INFORMATION AND ADVICE Programming ON/OFF times The default factory settings are shown, however if you wish to change these proceed as instructed below. Turn the battery on. The switch on the rear of the unit must be in either the Fully Pumped or Gravity position.