For help finding your model number, refer to our handy Finding Model Numbers guide here: http://www. If you notice that your clothes are not being washed evenly or getting tangled during the wash cycle, it's a sign of a damaged drum paddle lifter. A washing machine drain pump removes the dirty water out of the washing machine and into the drain hose or plumbing system.

Remove a Drum Paddle from a Washer: 8 Steps Simple Ways to Remove a Drum Paddle from a Washer: 8 Steps

Our spare parts are covered by our 1 year parts guarantee providing you the satisfaction necessary to bring your appliance back to life.You also need to make sure you keep it well cleaned so that it can effectively clean your laundry in turn. It should be very obvious when you pull the paddle far enough to release it because it will make a loud unsnapping sound and feel looser. That’s not a huge issue as these drum paddles are not hugely expensive but this video will help you get it right. The problem here is access to the rear retaining screw as it is not obvious how it's done, unless we tell you of course. If you have already purchased the item then we will review, and where possible, refund the difference.

Hotpoint Washing Machine Drum Paddle | Partmaster Hotpoint Washing Machine Drum Paddle | Partmaster

They snap into the washer drum and move your clothes around and direct the flow of water during a wash cycle. I have tried several times from 90° to 10° angles but the inner paddle seems to cut away in the middle and come loose making the paddle unusable. The machine is 15 months old and just outside year warranty and replaces the same model she had for 28 years so a very careful owner - she only uses once a week and never puts anything in it that is not clothes, sheets or towels.With this replacement carried out, your clothes should now be spinning properly and safely inside your appliance once again. This is how we do that, pull the washing machine out and tip it back so that it rests at about a 45˚ or so angle. The paddles arrived within the 3 day estimate they were great quality and very easy to fit the last time they were replaced that didn’t last very long only about 3 years due to them being non genuine parts but these are much better. Warning: Always unplug any appliance from the electricity supply before carrying out any work or testing on it. I have a paddle that has three sets of holes on one side (machine Hoover nextra8) I have looked at the tutuorial that you have on line but can not seem to get the old paddle out, it would appear that there is a small screw holding it in place by the drum, could you tell me how to get to this screw.